Engines / UDS Engines by part number / 01 - Engine [EV_ECM20TDI03L906022MG A01005] / Test / activation of fuel pump and control relay

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Part 1 of the order number Select the first three characters of the order number of the engine control unit. This number can be found in the VCDS when linked to the uniform in the SW order number field. Do not insert the ordering number from the control unit packaging here!!!

Select the first three characters of the order number of the engine control unit. This number can be found in the VCDS when linked to the uniform in the SW order number field. Do not insert the ordering number from the control unit packaging here!!!

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 7x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- on-board voltage > XXV - connect battery charger
- fuel system - closed
- fuse - fuel pump - OK
- engine speed = X rpm

Note:
- The pump must not run for a longer period without filling, there is a risk of seizure

connect with the control unit XX - engine

XX - Security access

enter value: XXXXX

Start

XX - Basic settings

X)
select item in menu: IDEXXXXX - fuel pump - Test

activate default settings

wait - XXs

basic settings -> Stop

X)
select item in menu: IDEXXXXX - fuel pump - Test

activate default settings

wait - XXs

basic settings -> Stop

X)
select item in menu: IDEXXXXX - fuel pump - Test

activate default settings

wait - XXs

End basic set-up

End of test

Log-in Buy