Engines / UDS Engines by part number / 01 - Engine [EV_ECM16TDI02103L906023PJ 003004] / Test of DPF differential pressure sensor 1 (G450)

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Part 1 of the order number Select the first three characters of the order number of the engine control unit. This number can be found in the VCDS when linked to the uniform in the SW order number field. Do not insert the ordering number from the control unit packaging here!!!

Select the first three characters of the order number of the engine control unit. This number can be found in the VCDS when linked to the uniform in the SW order number field. Do not insert the ordering number from the control unit packaging here!!!

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- engine temperature MIN XX°C (Advanced Measured Values IDEXXXXX-coolant temperature)
- engine speed = idling

wait XX s

connect with the control unit XX - engine

Advanced Measured Values

select item in menu:

IDEXXXXX-ENGXXXXXX - Diesel Particulate Filter: pressure difference sensor DIP_PF

TIP! For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

Start

increase rpm to XXXX rpm

wait X s

idling

required values =

Pressure - actual value (XXXX rpm) > Pressure - actual value (idling)

engine speed = X rpm
ignition = ON

Advanced Measured Values

select item in menu:

IDEXXXXX-ENGXXXXXX - Diesel Particulate Filter: pressure difference sensor - offset DIP_PF_[ADX]

TIP! For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

required value =

X hPa

if values are not achieved, check part:

- tube to sensor (tightness of line, mistaking)
- pressure difference sensor DPF - line
- pressure difference sensor DPF
engine speed = X rpm
ignition = ON
disconnect from power supply part: pressure difference sensor DPF
connector -> terminal X,X,X
measure voltage between terminals X,X - , required value = XV ± X.XV
measure voltage between terminals X,X - , required value = X.XXV ± X.XXV

end

Log-in Buy