Engines / UDS Engines by part number / 01 - Engine [EV_ECM16TDI02103L906023MP 003005] / Reset of DPF clogging

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Part 1 of the order number Select the first three characters of the order number of the engine control unit. This number can be found in the VCDS when linked to the uniform in the SW order number field. Do not insert the ordering number from the control unit packaging here!!!

Select the first three characters of the order number of the engine control unit. This number can be found in the VCDS when linked to the uniform in the SW order number field. Do not insert the ordering number from the control unit packaging here!!!

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 3x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Note:
- after replacement of the DPF, the clogged filter remains in the control unit and must be deleted
- done after replacement of component:
Diesel Particulate Filter (enter value: XX XX)
engine control unit (enter value from initial control unit)
- if engine control unit has been replaced, it is also necessary to do DPF service regeneration !!!

- if the clogging value from the initial unit, it is calculated in such a manner that the number of kilometres travelled on the DPF is divided by the coefficient XXXX and rounded down to full digits. For example: XXX,XXX km divided by XXXX = XX, the clogging value is XX, it is stored as XX XX.

connect with the control unit XX - engine

Advanced Measured Values

select item in menu:

IDEXXXXX-ENGXXXXXX - Diesel Particulate Filter: soot clogging - MASS_ASH_PF

TIP! For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

measured value = soot clogging

XX - Security access

enter value:

XXXXX = function accessible: adaptation

Start

XX - Adaptation

select item in menu: IDEXXXXX - Diesel Particulate Filter: initialization

TIP! For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

Read

enter value:

If replaced:

- Diesel Particulate Filter - enter value: X.XXXX
- engine control unit - enter value from initial control unit

Start

switch ignition off for: XXs

check of error memory

XX - end of communication

Log-in Buy