Engines / UDS Engines by part number / 01 - Engine [EV_ECM18TFS0218K0906264A 001003] / Basic settings - Charge Pressure Controller

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Part 1 of the order number Select the first three characters of the order number of the engine control unit. This number can be found in the VCDS when linked to the uniform in the SW order number field. Do not insert the ordering number from the control unit packaging here!!!

Select the first three characters of the order number of the engine control unit. This number can be found in the VCDS when linked to the uniform in the SW order number field. Do not insert the ordering number from the control unit packaging here!!!

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 1x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- on-board voltage XXV
- engine temperature XX°C
- engine speed X rpm

Note:
-done after installation of a component: filling pressure controller

connect with the control unit XX - engine

XX - Basic settings

select item in drop-down menu:

IDEXXXXX - Test: filling pressure controller - Terminal value

In the Basic Settings window, click Measured values and select the items you want to visualize.

IDEXXXXX - filling pressure controller: status - STATE_BPA[X]
IDEXXXXX - filling pressure controller: actual value - POS_BPA[X]

TIP! For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window

activate default settings (duration approx XX minutes)

required values

IDEXXXXX - filling pressure controller: status - STATE_BPA[X] = OPM

End of test

Log-in Buy