Engines / UDS Engines by part number / 01 - Engine [EV_ECM10CSI01104C906025CG 001004] / Test - throttle actuator
Mark | Model | Control unit | Diagnostic operation |
---|
Mark
Model
Part 1 of the order number
Part 2 of the order number
Part 3 of the order number
Part 4 of the order number
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
• engine speed = X rpm
connect with the control unit XX - engine
accelerator pedal - released
Advanced Measured Values
select item in menu:
IDEXXXXX - throttle valve position - Absolute value - sensor X
IDEXXXXX - throttle valve position - sensor X
TIP! For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window
Start
Move the line and connector connection on the sensor and observe whether the values do not change sharply
required values
IDEXXXXX = XX% - XX% (gas pedal position sensor X (GXX))
IDEXXXXX = XX% - XX% (gas pedal position sensor X (GXXX))
fully depress accelerator pedal
(values must rise smoothly, it is recommended to use a graphics display for this function)
required values - accelerator pedal XXX%
IDEXXXXX = XX% - XX% (gas pedal position sensor X)
IDEXXXXX = XX% - XX% (gas pedal position sensor X)
Picture documentation:
XX - end of communication
• engine speed = X rpm
connect with the control unit XX - engine
accelerator pedal - released
Advanced Measured Values
select item in menu:
IDEXXXXX - throttle valve position - Absolute value - sensor X
IDEXXXXX - throttle valve position - sensor X
TIP! For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window
Start
Move the line and connector connection on the sensor and observe whether the values do not change sharply
required values
IDEXXXXX = XX% - XX% (gas pedal position sensor X (GXX))
IDEXXXXX = XX% - XX% (gas pedal position sensor X (GXXX))
fully depress accelerator pedal
(values must rise smoothly, it is recommended to use a graphics display for this function)
required values - accelerator pedal XXX%
IDEXXXXX = XX% - XX% (gas pedal position sensor X)
IDEXXXXX = XX% - XX% (gas pedal position sensor X)
Picture documentation:
XX - end of communication
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.