Engines / UDS Engines by part number / 01 - Engine [EV_ECM10TFS01104C906025AP 003001] / Camshaft - Position sensor: adaptation

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Part 1 of the order number Select the first three characters of the order number of the engine control unit. This number can be found in the VCDS when linked to the uniform in the SW order number field. Do not insert the ordering number from the control unit packaging here!!!

Select the first three characters of the order number of the engine control unit. This number can be found in the VCDS when linked to the uniform in the SW order number field. Do not insert the ordering number from the control unit packaging here!!!

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
•         engine speed = Xrpm
•         coolant temperature > XX°C

Note:
done after replacement of component:
•         hall sensor
•         rotation sensor GXX
•         adjusting camshaft valve
•         camshaft

connect with the control unit XX - engine

XX - Security access

enter value XXXXX

Start

XX - Basic settings

select item in menu: IDEXXXXX - camshaft - Position sensor: zeroing learning values

Input the parameter: X

Start

follow the diagnostics instructions

desired condition: Successfully completed

End basic set-up

back

XX - end of communication

switch ignition off for XXs

connect with the control unit XX - engine

XX - Security access

enter value XXXXX

Start

XX - Basic settings

select item in menu: IDEXXXXX - camshaft - Position sensor: adaptation

Start

follow the diagnostics instructions

desired condition: Successfully completed

End basic set-up

back

XX - end of communication

End of test

Log-in Buy