Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator
Gearboxes / 6-speed / 6-speed automatic transmission Mulitronic / Adaptation - driving test
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- ignition - ON
- engine speed = idling
- number of faults = X
- oil temperature - gearbox = XX°- XX°
- driving and braking must be possible at minimum power!
Note:
- done after repair of components: input shaft, hydraulic unit, gearbox - control unit, gearbox
XX - Adaptation channel XXX
enter value: XXX
Save
XX - Measured values group XXX, XXX
required values:
field X = TestON
Move the gear selector to position D and drive for a distance of XXm at minimum engine load, then Stop Hold the brake pedal for XX seconds, move the gear selector to position R and travel a distance of Xm at minimum load and Stop. Hold the brake pedal for XX seconds
required values:
field X = ADP-OK
Created on: XX.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
- ignition - ON
- engine speed = idling
- number of faults = X
- oil temperature - gearbox = XX°- XX°
- driving and braking must be possible at minimum power!
Note:
- done after repair of components: input shaft, hydraulic unit, gearbox - control unit, gearbox
XX - Adaptation channel XXX
enter value: XXX
Save
XX - Measured values group XXX, XXX
required values:
field X = TestON
Move the gear selector to position D and drive for a distance of XXm at minimum engine load, then Stop Hold the brake pedal for XX seconds, move the gear selector to position R and travel a distance of Xm at minimum load and Stop. Hold the brake pedal for XX seconds
required values:
field X = ADP-OK
Created on: XX.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.