• Diagnostic procedures for a VAG diagnostics
• Database for coding vehicle control units Volkswagen - VAG
• Software versions
• VIN - Code validator

Gearboxes / 7-speed / 7-speed Direct Shift Gearbox (DSG) (GSG DQ200) UDS / Test - play of clutch control mechanism K1; K2

Search: Search area: All Procedure name Procedure content Engine code Search Reset

Mark	Model	Control unit	Diagnostic operation

Displayed 1-20 records out of 100. << < 1 > >>

Mark

Škoda VW Audi Seat Porsche Bentley MAN Service intervals Engines Gearboxes Immobilizers auxiliary heater

Model

4-speed 5-speed 6-speed 7-speed Gearbox 09D Gearbox 0AT

Control unit

7-speed Direct Shift Gearbox (DSG) (DSG/0AM) 7-speed Direct Shift Gearbox (DSG) (GSG DQ200) UDS

Diagnostic operation

Test - play of clutch control mechanism K1; K2

This operation was considered useful 5x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and  You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Note:
- second mechanic necessary
- for this test, it is suitable to use graphical representation

observe the occupation safety rules when taking a test drive with connected diagnostics tester



connect with the control unit XX - gearbox electronics



clutch KX

XX - Measured values UDS

select item in menu:
IDEXXXX - clutch X required value (mm)
IDEXXXX - clutch X actual value (mm)

do a drive test with manually engaged gear number: X

observe values:
IDEXXXX= position of clutch control mechanism KX GXXX (required value)
IDEXXXX= position of clutch control mechanism KX GXXX (actual value)


desired condition:
clutch X required value = X mm
clutch X actual value > X mm


play of clutch control mechanism KX =

clutch X actual value - clutch X required value

required value > X mm



clutch KX

XX - Measured values UDS


select item in menu:
IDEXXXX - clutch X required value (mm)
IDEXXXX - clutch X actual value (mm)

do a drive test with manually engaged gear number: X

observe values:
IDEXXXX = position of clutch control mechanism KX GXXX (required value)
IDEXXXX= position of clutch control mechanism KX GXXX (actual value)


desired condition:
clutch X required value = X mm
clutch X actual value > X mm


play of clutch control mechanism KX =

clutch X actual value - clutch X required value

required value > X mm


Picture documentation:

+ clutch measurement

Created on: XX.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and  You will get login to diagnostic procedures database imediatelly.

Log-in Buy