Gearboxes / Gearbox 0AT / Automatic gearbox 0AT / basic settings

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in

Note:
- the feasibility of this test may depend on the equipment of the control unit
- done after repair of components:
engine
engine - coding
automatic transmission
automatic transmission - control unit
accelerator pedal
- on-board voltage > XXV
- gear lever = P
- ignition = ON
- engine speed = X rpm

connect with the control unit XX - gearbox electronics

XX - Basic settings group XXX

activate default settings

smoothly depress - accelerator pedal - full way

after stabilisation of values - continue

wait XXs

further, do:

- engine control unit: basic settings - Kick-down

end

Log-in