MAN / MAN TGE (UZ) / 42 - Door electronics driver’s side [EV_DCU2DriveSideMAXHCONT 001005] / Door electronics driver’s side - basic settings

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 1x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

connect with the control unit XX - door electronics - driver’s side

XX - Basic settings

in front

select item in drop-down menu:
IDEXXXXX-ENGXXXXXX - Zeroing of standardisation - LF window

Start

required value: Successfully completed

select item in drop-down menu:
IDEXXXXX-ENGXXXXXX - RF window

In the parameter menu, select:
standardization: software Stop, adaptation

Start

required value: Successfully completed

in rear

select item in drop-down menu:
IDEXXXXX-ENGXXXXXX - Zeroing of standardisation - LR window

Start

required value: Successfully completed

select item in drop-down menu:
IDEXXXXX-ENGXXXXXX - RR window

In the parameter menu, select:
standardization: software Stop, adaptation

Start

required value: Successfully completed

XX - end of communication

switch ignition off for XXs

End of test

Log-in Buy