Seat / Toledo (NH) / 61 - Battery control (Batt.regelung) / Battery - replacement

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 13x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Note:
- the feasibility of this test may depend on the equipment of the control unit
- also read the procedure: XX - Gateway -> Battery - replacement

connect with the control unit XX - Battery control

XX - Adaptation channel XX

enter value: CCC VVV SSSSSSSSSS

CCC = Battery - capacity
for instance XX Ah - enter as XXX

VVV = manufacturer
UMX = Akuma
VAX = Varta
BAX = Banner
MLA = Moll
TUX = Exide
JCB = JCI
XDO = Boading

SSSSSSSSSS = Battery - serial number BEM (see manufacturer’s label)
for instance serial number XXXXXXX - enter as XXXXXXXXXX

Test

Save

switch ignition off for XX s

Log-in Buy