Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator
Škoda / Octavia (1U) / 03 - Brake electronics MK 20 / basic settings
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
steering wheel turn angle sensor (GXX) - settings
drive the car over a short path with a maximum speed of XX km/h
sharply turn the steering wheel left and right in an angle of at least XX°, straighten the steering wheel and Stop the vehicle
do not move the steering wheel!
connect with the control unit XX - Brake electronics
XX - Login / XX - Coding II
enter value: XXXXX
Start
XX - Basic settings group XXX
Start
required values:
field X = OK
drive the car over a short path with a maximum speed of XX km/h
XX - Measured values group XXX
required values:
field X = -X,X - +X,X°
transverse acceleration sensor - settings
XX - Measured values group XXX
required values:
field X = -X,X° m/sX - + X.X° m/sX
XX - Login / XX - Coding II
enter value: XXXXX
Start
XX - Basic settings group XXX
Start
wait XXs
required values:
field X = OK
XX - Measured values group XXX
required values:
field X = -X,X° - + X.X°
brake fluid pressure sensor (GXXX) - settings
Conditions:
- brake pedal released
- on-board voltage > XXV
connect with the control unit XX - Brake electronics
XX - Login / XX - Coding II
enter value: XXXXX
Start
XX - Basic settings group XXX
Start
wait XXs
required values:
field X = OK
XX - Measured values group XXX
required values:
field X = -X,X - +X,X bar
longitudinal acceleration sensor (GXXX) - settings
Conditions:
- on-board voltage > XXV
connect with the control unit XX - Brake electronics
XX - Login / XX - Coding II
enter value: XXXXX
Start
XX - Basic settings group XXX
Start
wait XXs
required values:
field X = OK
XX - Measured values group XXX
required values:
field X = -X,X - +X,Xm/sX.
Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.