Škoda / Octavia III (NE) / 6D - Gull-wing door HDSG-Modul [EV_HDSGVW428 201133] / Rear lid/tailgate/boot lid - opening angle - settings

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 1x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

done after repair of components:
•         rear lid/tailgate/boot lid - engine X (VXX)
•         rear lid/tailgate/boot lid - engine X (VXX)
•         rear lid/tailgate/boot lid - control unit
•         rear lid/tailgate/boot lid

Conditions:
- tailgate - closed

connect with the control unit XD - gull-wing door

XX - Basic settings

select item in menu - IDEXXXXX-ENGXXXXXX - setting of the angle of gull-wing doors

TIP (For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window )

do not interrupt communication

press the switch in the door handle, the door starts opening and for the entire duration of the opening process, a regular beep is emitted

the door runs to terminal position, it is necessary to leave the door here until a quick double beep is heard

press the button on the door to close, for the duration of the closing process, a regular beep is heard until full closure and locking

End basic set-up

XX - end of communication

Created on: XX.X.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy