Škoda / Octavia III (NE) / 03 - Brake electronics MK100 IPB ESC [EV_Brake1UDSContiMK100IPB 033001] / Replacement of brake pads

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 10x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Note:
- Functional tests of the brake pedal and parking brake may be done only with properly installed brake pads and callipers.
- Comply PRECISELY with the following procedure. Every step has its own substantiation.
- If you don precisely adhere to this procedure, the system could behave in an unexpected manner, which it need not be possible to repair.

- wait for minimum XX seconds after brakes come to rest before the next step
due to an error in the firmware of some units, this could result in damage to the control module

release of parking brake

Conditions:
- connect battery charger
- brake pedal - released

activate the hand brake
release the hand brake

Note:
- In this operation, it is normal that the LED on the parking brake and the warning indicator light on the dashboard blink rapidly.

connect with the control unit XX - brake electronics

XX - Basic settings

select item in drop-down menu: IDEXXXXX-ENGXXXXXX- Mode for replacement of the brake pads - Start

Start

the callipers open

!!! Wait for XX seconds after end of the motion of the brake pads !!!

XX - end of communication

replace the brake pad

engagement of parking brake

Conditions:
- connect battery charger
- brake pedal - released

Note:
- In this operation, it is normal that the LED on the parking brake and the warning indicator light on the dashboard blink rapidly.

connect with the control unit XX - brake electronics

XX - Basic settings

select item in drop-down menu: IDEXXXXX-ENGXXXXXX- Mode for replacement of the brake pads - end

Start

the callipers close

XX - end of communication

activate the hand brake

release the hand brake

functional test

Conditions:
- connect battery charger
- the vehicle must be standing on a level surface
- brake pedal = released

activate the hand brake

release the hand brake

connect with the control unit XX - brake electronics

XX - Basic settings

select item in drop-down menu: IDEXXXXX-ENGXXXXXX - Check of the EPB – electromechanical parking brake function

Start

The callipers run through X braking and release cycles.

!!! Wait for XX seconds after end of the motion of the brake pads !!!

XX - end of communication

Created on: XX.X.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy