Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator
Škoda / Superb (3U) / 14 - Shock absorption (DAEMPFUNGS-SG H07) / basic settings
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- on-board voltage > XXV
- slightly lift the vehicle, axle spring travel
Note:
- done after replacement of component: control unit - XX - Shock absorption, vehicle ride height sensor
- done after repair of components: control unit - XX - Shock absorption, vehicle ride height sensor
connect with the control unit XX - Shock absorption
XX - Measured values group XXX
observe values
field X = height LF wheel (%)
field X = height RF wheel (%)
field X = height LR wheel (%)
field X = height RR wheel (%)
XX - Measured values group XXX
observe values
field X = MIN learning value - LF wheel (%)
field X = MAX learning value - LF wheel (%)
field X = MIN learning value - RF wheel (%)
field X = MAX learning value - RF wheel (%)
XX - Measured values group XXX
observe values
field X = MIN learning value - LR wheel (%)
field X = MAX learning value - LR wheel (%)
field X = MIN learning value - LF wheel (%)
field X = MAX learning value - LF wheel (%)
desired condition:
MIN learning value XX wheel < height XX wheel < MAX learning value XX wheel
if values are not achieved:
- vehicle ride height sensor - adjust position
upon achievement of values: continue
XX - Basic settings group XXX
activate default settings
after stabilisation of values: end
switch ignition off for XXs
- on-board voltage > XXV
- slightly lift the vehicle, axle spring travel
Note:
- done after replacement of component: control unit - XX - Shock absorption, vehicle ride height sensor
- done after repair of components: control unit - XX - Shock absorption, vehicle ride height sensor
connect with the control unit XX - Shock absorption
XX - Measured values group XXX
observe values
field X = height LF wheel (%)
field X = height RF wheel (%)
field X = height LR wheel (%)
field X = height RR wheel (%)
XX - Measured values group XXX
observe values
field X = MIN learning value - LF wheel (%)
field X = MAX learning value - LF wheel (%)
field X = MIN learning value - RF wheel (%)
field X = MAX learning value - RF wheel (%)
XX - Measured values group XXX
observe values
field X = MIN learning value - LR wheel (%)
field X = MAX learning value - LR wheel (%)
field X = MIN learning value - LF wheel (%)
field X = MAX learning value - LF wheel (%)
desired condition:
MIN learning value XX wheel < height XX wheel < MAX learning value XX wheel
if values are not achieved:
- vehicle ride height sensor - adjust position
upon achievement of values: continue
XX - Basic settings group XXX
activate default settings
after stabilisation of values: end
switch ignition off for XXs
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.