VW / Beetle (5C) / 03 - Brake electronics MK60 EC1 / Setting of transverse acceleration sensor (G200)

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- on-board voltage > XXV
- engine speed = idling

connect with the control unit XX - Brake electronics

drive the car over a short path with a maximum speed of XX km/h
sharply turn the steering wheel left and right in an angle of at least XX°, straighten the steering wheel and Stop the vehicle
do not move the steering wheel!

XX - Measured values group XXX
required values:
field X = -X,X° m/sX - + X.X° m/sX

XX - Login / XX or Coding II or XX - Security access
enter value: XXXXX
Start

XX - Basic settings group XXX
Start

wait XXs
required values:
field X = OK

XX - Measured values group XXX
required values:
field X = -X,X° - + X.X°

Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy