VW / Caddy (SK) / 15 - Airbag VW40Airbag [EV_AirbaVW40ALVVW38X 001012] / Seat belt tensioner – actuator test

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Do not perform belt retraction tests unnecessarily. After exceeding the maximum number of retractions, the belt will need to be replaced

Note:
•         During this test, belt retraction with a force of XXX N will be activated!

Conditions:
•         vehicle at idle
•         engine speed X rpm
•         on-board voltage XXV - XXV
•         Crash data must not be stored
•         The system must be complete and all connectors connected
•         safety belt = ON!!!
•         The maximum number of belt tensionings must not be exceeded (Advanced Measured Values)
•         This procedure may require the hood to be opened or the SFD protection to be unlocked

Do not perform belt retraction tests unnecessarily. After exceeding the maximum number of retractions, the belt will need to be replaced

Warning: Exercise maximum caution for safety reasons when repairing Airbag systems Do not measure cable harnesses with ignition on

connect with the control unit XX – Airbag

XX - Security access

enter value: XXXXX

if it shall not be accepted, the unit does not require a safe approach

Start

XX - Actuators

select item in drop-down menu: IDEXXXXX Safety Seat belt tensioners

In the parameter menu, select: left / right side

•         fasten Seat belt
•         pull the Seat belt out firmly and hold it – use gloves
•         After clicking Start, the belt will retract sharply; let it slip through your glove

Start

physically test the function of the activated component

XX - end of communication

End of test

Created on: XX.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy