Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator
VW / Crafter (2E) / 9F - Stat. heater (water) / Adaptation of remote control device
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Note:
- it is possible to programme a maximum of X remote control devices
X) press the “UP” button the auxiliary heater and hold it for XX seconds. (red LED diode on, heating aggregate does not Start)
X) after lapse of XX s, the red LED diode blinks. (it is now possible to Start the programming process)
X) release the “UP” button on the auxiliary heater (within X seconds). (LED diode continues to blink, heating aggregate does not Start)
X) press the on button within X seconds. (initiation of programming process)
in the process, the code of the controller is stored in the receiver of the radio remote control device.
X) within the next X seconds, press the off button. (the programming process starts)
in the process programming is done only for this transmitter, all other transmitters are deleted.
X) after successful completion of the programming process, a short impulse is activated on the remote radio control receiver, switching line, to the auxiliary heating aggregate and the red LED diode stops blinking.
Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
- it is possible to programme a maximum of X remote control devices
X) press the “UP” button the auxiliary heater and hold it for XX seconds. (red LED diode on, heating aggregate does not Start)
X) after lapse of XX s, the red LED diode blinks. (it is now possible to Start the programming process)
X) release the “UP” button on the auxiliary heater (within X seconds). (LED diode continues to blink, heating aggregate does not Start)
X) press the on button within X seconds. (initiation of programming process)
in the process, the code of the controller is stored in the receiver of the radio remote control device.
X) within the next X seconds, press the off button. (the programming process starts)
in the process programming is done only for this transmitter, all other transmitters are deleted.
X) after successful completion of the programming process, a short impulse is activated on the remote radio control receiver, switching line, to the auxiliary heating aggregate and the red LED diode stops blinking.
Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.