VW / Crafter (SY) / 15 - Airbag [EV_AirbaVW22TS6VW48X 001032] / Detection of seat occupancy - serial number

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

This is an UNVERIFIED procedure. Please let us know your experience with performing this procedure at info@pc-autodiagnostika.cz

Note:
•         done after replacement of component: detection of Seat occupancy

Conditions:
•         vehicle at idle
•         engine speed X rpm
•         on-board voltage XXV - XXV
•         Crash data must not be stored
•         The system must be complete and all connectors connected
•         This procedure may require the hood to be opened or the SFD protection to be unlocked

Warning: Exercise maximum caution for safety reasons when repairing Airbag systems Do not measure cable harnesses with ignition on

connect with the control unit XX – Airbag

XX - Security access

enter value: XXXXX

if it shall not be accepted, the unit does not require a safe approach

Start

XX - Basic settings

select item in drop-down menu: MASXXXXX - detection of Seat occupancy - serial number

Start

wait

desired condition: Successfully completed

XX - end of communication

switch ignition off for XX s

End of test

This is an UNVERIFIED procedure. Please let us know your experience with performing this procedure at info@pc-autodiagnostika.cz

Created on: X.X.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy