Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator- Scan Explorer
VW / e-tron (GE) / 74 - Chassis Control [EV_ChassContrContiAU651 003018] / Towing gear (Equipment for connection of trailer) - coding
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Note:
• This unit uses long coding, use the AutoComSoft on-line system, or any calculator, e.g. LCode
• To change coding, the control unit must be restarted. In VCDS, in the coding window, tick the Soft reset option
• This procedure may require the hood to be opened or the SFD protection to be unlocked
• This procedure may require temporary deactivation of the Gateway diagnostic filter
connect with the control unit XX - Body electronics
XX - Coding
Coding calculator
Byte XX (the first byte in the sequence is counted as the zero byte)
bit X (the first bit in order is counted as the seventh, then down to zero)
TIP: In the coding calculator, use the drop-down menu or checkboxes to make your selection.
Manual Byte assembly in the coding calculator:
enter value (BIN):
Xxxxxxxx = towing gear - NO
Xxxxxxxx = towing gear - YES
After assembling the byte, press ENTER on the keyboard
To change coding, the control unit must be restarted. In VCDS, in the coding window, tick the Soft reset option
Picture documentation:
Start
End of test
Created on: X.X.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
• This unit uses long coding, use the AutoComSoft on-line system, or any calculator, e.g. LCode
• To change coding, the control unit must be restarted. In VCDS, in the coding window, tick the Soft reset option
• This procedure may require the hood to be opened or the SFD protection to be unlocked
• This procedure may require temporary deactivation of the Gateway diagnostic filter
connect with the control unit XX - Body electronics
XX - Coding
Coding calculator
Byte XX (the first byte in the sequence is counted as the zero byte)
bit X (the first bit in order is counted as the seventh, then down to zero)
TIP: In the coding calculator, use the drop-down menu or checkboxes to make your selection.
Manual Byte assembly in the coding calculator:
enter value (BIN):
Xxxxxxxx = towing gear - NO
Xxxxxxxx = towing gear - YES
After assembling the byte, press ENTER on the keyboard
To change coding, the control unit must be restarted. In VCDS, in the coding window, tick the Soft reset option
Picture documentation:
Start
End of test
Created on: X.X.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
