VW / Lupo (6E-6X) / 25 – immobiliser / Adaptation after replacement of engine control unit from 00 with CAN-Bus
Mark | Model | Control unit | Diagnostic operation |
---|
Mark
Model
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- install component: engine control unit
- before this operation, take down the identification and coding of the initial control unit
- first execute the function: Coding
connect with the control unit XX - engine
XX - Adaptation channel XX
enter value: Vehicle PIN
Test
Save
system indicator light: Immobiliser - off
switch ignition off for: XX s
check of error memory
Note:
- If this procedure is not done properly, the immobilizer blocks for XX minutes; it is necessary to switch-off the ignition and wait.
- The newly installed and adapted control unit has adopted the VIN, SKZ and PIN and shall continue to use initial PIN of the vehicle
Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
- install component: engine control unit
- before this operation, take down the identification and coding of the initial control unit
- first execute the function: Coding
connect with the control unit XX - engine
XX - Adaptation channel XX
enter value: Vehicle PIN
Test
Save
system indicator light: Immobiliser - off
switch ignition off for: XX s
check of error memory
Note:
- If this procedure is not done properly, the immobilizer blocks for XX minutes; it is necessary to switch-off the ignition and wait.
- The newly installed and adapted control unit has adopted the VIN, SKZ and PIN and shall continue to use initial PIN of the vehicle
Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.