VW / Passat B6 (3C) / 14 - Shock absorption (DAEMPFUNGS-SG H07) / basic settings

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- on-board voltage > XXV
- slightly lift the vehicle, axle spring travel

Note:
- done after replacement of component: control unit - XX - Shock absorption, vehicle ride height sensor
- done after repair of components: control unit - XX - Shock absorption, vehicle ride height sensor

connect with the control unit XX - Shock absorption

XX - Measured values group XXX
observe values
field X = height LF wheel (%)
field X = height RF wheel (%)
field X = height LR wheel (%)
field X = height RR wheel (%)

XX - Measured values group XXX
observe values
field X = MIN learning value - LF wheel (%)
field X = MAX learning value - LF wheel (%)
field X = MIN learning value - RF wheel (%)
field X = MAX learning value - RF wheel (%)

XX - Measured values group XXX
observe values
field X = MIN learning value - LR wheel (%)
field X = MAX learning value - LR wheel (%)
field X = MIN learning value - LF wheel (%)
field X = MAX learning value - LF wheel (%)

desired condition:

MIN learning value XX wheel < height XX wheel < MAX learning value XX wheel

if values are not achieved:
- vehicle ride height sensor - adjust position

upon achievement of values: continue

XX - Basic settings group XXX
activate default settings

after stabilisation of values: end

switch ignition off for XXs

Log-in Buy