VW / Passat B6 (3C) / 5C - Lane assist (HCA) CAN / calibration

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- install calibration jig VASXXXX

Note:
done after repair of components:
- control unit - XC - Lane assist
- windscreen
- vehicle ride height sensor

connect with the control unit XC - Lane assist

XX - Adaptation channel XXX

Measure the height from the ground to the lower edge of the fender at wheel centre (LF wheel) = A

enter value: A
for instance: height XX,X cm enter as XXX

Test
Save

XX - Adaptation channel XXX

Measure the height from the ground to the lower edge of the fender at wheel centre (RF wheel) = B

enter value: B
for instance: height XX,X cm enter as XXX

Test
Save

XX - Adaptation channel XXX

Measure the height from the ground to the lower edge of the fender at wheel centre (LR wheel) = C

enter value: C
for instance: height XX,X cm enter as XXX

Test
Save

XX - Adaptation channel XXX

Measure the height from the ground to the lower edge of the fender at wheel centre (RR wheel) = D

enter value: D
for instance: height XX,X cm enter as XXX

Test
Save

XX - Security access

enter value: XXXX

Start

XX - Basic settings group XXX
activate default settings

wait X MIN

after stabilisation of values

XX - Basic settings group XXX
activate default settings

wait X MIN

after stabilisation of values

end

Log-in Buy