VW / Passat B7 (36) / 13 - adaptive distance control ( AC201 RDW) CAN / setting

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 1x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Note:
done after repair of components:
- test / wheel alignment
- front cross-member
- distance control - control unit

locate the vehicle on a device for measurement and setting of the wheel alignment

install calibration jig VAS XXXX or VAG XXXX

connect with the control unit XX - Distance control

XX - Measured values group XXX
observe values
field X = A (horizontal settings)
field X = B (vertical settings)

using a calibration jig and setting bolts, set-up the unit for control of the distance behind the vehicle in front according to the following formula

horizontal settings
required value = A x XX

vertical settings
required value = B x XX

XX - Adaptation channel XX

enter value:
XXXX

Test
Save

switch ignition off for XXs

Log-in Buy