Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator
VW / Passat CC (35) / 5C - Lane assist (HCA) CAN / calibration
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- install calibration jig VASXXXX
Note:
done after repair of components:
- control unit - XC - Lane assist
- windscreen
- vehicle ride height sensor
connect with the control unit XC - Lane assist
XX - Adaptation channel XXX
Measure the height from the ground to the lower edge of the fender at wheel centre (LF wheel) = A
enter value: A
for instance: height XX,X cm enter as XXX
Test
Save
XX - Adaptation channel XXX
Measure the height from the ground to the lower edge of the fender at wheel centre (RF wheel) = B
enter value: B
for instance: height XX,X cm enter as XXX
Test
Save
XX - Adaptation channel XXX
Measure the height from the ground to the lower edge of the fender at wheel centre (LR wheel) = C
enter value: C
for instance: height XX,X cm enter as XXX
Test
Save
XX - Adaptation channel XXX
Measure the height from the ground to the lower edge of the fender at wheel centre (RR wheel) = D
enter value: D
for instance: height XX,X cm enter as XXX
Test
Save
XX - Security access
enter value: XXXX
Start
XX - Basic settings group XXX
activate default settings
wait X MIN
after stabilisation of values
XX - Basic settings group XXX
activate default settings
wait X MIN
after stabilisation of values
end
- install calibration jig VASXXXX
Note:
done after repair of components:
- control unit - XC - Lane assist
- windscreen
- vehicle ride height sensor
connect with the control unit XC - Lane assist
XX - Adaptation channel XXX
Measure the height from the ground to the lower edge of the fender at wheel centre (LF wheel) = A
enter value: A
for instance: height XX,X cm enter as XXX
Test
Save
XX - Adaptation channel XXX
Measure the height from the ground to the lower edge of the fender at wheel centre (RF wheel) = B
enter value: B
for instance: height XX,X cm enter as XXX
Test
Save
XX - Adaptation channel XXX
Measure the height from the ground to the lower edge of the fender at wheel centre (LR wheel) = C
enter value: C
for instance: height XX,X cm enter as XXX
Test
Save
XX - Adaptation channel XXX
Measure the height from the ground to the lower edge of the fender at wheel centre (RR wheel) = D
enter value: D
for instance: height XX,X cm enter as XXX
Test
Save
XX - Security access
enter value: XXXX
Start
XX - Basic settings group XXX
activate default settings
wait X MIN
after stabilisation of values
XX - Basic settings group XXX
activate default settings
wait X MIN
after stabilisation of values
end
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.