Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator
VW / Polo 96-02 (6N) / Immobilizer generation 1 / Adaptation after replacement of immobiliser control unit (also older)
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- install component: XX - Immobilizer
- before this operation, take down the identification and coding of the initial control unit
- first execute the function: Coding
- first execute the function: Adaptation of the vehicle keys
connect with the control unit XX - Immobilizer
XX - Login
(some units do not require this Login procedure)
enter value: PIN of new immobilizer control unit (instrument panel)
for instance XXXX enter as XXXXX
Start
XX - Adaptation channel XX
enter value: XXX
Save
switch ignition off for: XX s
check of error memory
Note:
- If this procedure is not done properly, the immobilizer blocks for XX minutes; it is necessary to switch-off the ignition and wait.
- The newly installed and adapted control unit has adopted the VIN, SKZ and PIN and shall continue to use initial PIN of the vehicle
Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
- install component: XX - Immobilizer
- before this operation, take down the identification and coding of the initial control unit
- first execute the function: Coding
- first execute the function: Adaptation of the vehicle keys
connect with the control unit XX - Immobilizer
XX - Login
(some units do not require this Login procedure)
enter value: PIN of new immobilizer control unit (instrument panel)
for instance XXXX enter as XXXXX
Start
XX - Adaptation channel XX
enter value: XXX
Save
switch ignition off for: XX s
check of error memory
Note:
- If this procedure is not done properly, the immobilizer blocks for XX minutes; it is necessary to switch-off the ignition and wait.
- The newly installed and adapted control unit has adopted the VIN, SKZ and PIN and shall continue to use initial PIN of the vehicle
Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.