VW / Polo from 02 (9N) / 03 - Brake electronics Bosch 8.0 / Calibration of wheel turn angle sensor (G85)

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- number of faults = X
- test / wheel alignment
- steering wheel turn angle sensor - faultless

drive the car over a short path with a maximum speed of XX km/h
Stop in straight direction, do not switch of the ignition

connect with the control unit XX - brake electronics

turn the steering wheel XX° left
turn the steering wheel - straight direction

XX - Measured values group XXX
observe values:
field X = X,X° ±X° (steering wheel turn angle sensor)

XX - Security access / XX - Login / XX - Coding II

enter value: XXXXX

Start

XX - Basic settings group XXX
Start

wait XX s

check of error memory

end

XX - end of communication

Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy