VW / Sharan (7N) / 6C - reverse camera (J772__Rearview) CAN / calibration

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

This operation was considered useful 1x.

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Note:
- done after replacement of component: rear camera, rear camera - control unit
- done after repair of components: rear axle, rear section of the vehicle

Conditions:
- install calibration jig (VAS XXXX)
- the vehicle must stand on even ground
- the vehicle must not be moved
- tailgate - closed
- control - straight direction - steering wheel turn angle = X.X°
- ignition = ON
- engine speed = X
- rear camera - active
- MMI shows the picture from the reverse camera
- for height-adjustable vehicles, set the automatics

connect with the control unit XC - Reverse camera

XX - Security access
enter value: XXXXX
Start

XX - Adaptation channel XXX - height

measure the height from the floor to the camera [mm] = B

enter value: height B (measured value)
for instance: height XXXXmm enter as XXXX

Test
Save

XX - Adaptation channel XXX - height

measure the height of the calibration jig from the floor [mm] = H

basic value = XXXmm

enter value: XXX + height H (measured value)
for instance: height XXmm enter as XXX (XXXmm+XXmm)
Test
Save

XX - Adaptation channel XXX - distance

measure the distance of the calibration jig from the rear axle [mm] = A

enter value: XXXXX - wheelbase - A (measured value)

wheelbase
Amarok (XH) = XXXX mm
Passat (XC) = XXXX mm
Passat CC (XX) = XXXX mm
Passat (XX) = XXXX mm
Phaeton (XD) = XXXX mm
Phaeton (XD) Long = XXXX mm
Sharan (XN)
Alhambra (XN) = XXXX mm
Tiguan (XN) = XXXX mm
Touareg (XL) = XXXX mm
Transporter/Multivan (XE) = XXXX mm
Transporter/Multivan (XF) Long = XXXX mm

for instance: Passat (XC) enter as XXXXX (XXXXX - XXXX - A (measured value = XXXX) )

Test
Save

XX - Adaptation channel XXX - storage of values

enter value: X

Test
Save

Test

XX - Measured values group XXX
required values:
field X = XxXXXX (Calibration - status)

XX - end of communication

Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy