Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator
VW / Touareg (7L) / 03 - brake electronics / Setting of longitudinal acceleration sensor G251
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- engine speed = idling
- on-board voltage > XXV
Start the engine
turn the steering wheel full way - right side
turn the steering wheel full way - left
drive the car over a short path with a maximum speed of XX km/h
Stop in straight direction, do not switch of the ignition - engine speed = idling
connect with the control unit XX - Brake electronics
XX - Measured values group XXX
required values:
field X = -X,X - +X,Xm/sX
connect with the control unit XX - Parking brake/Handbrake
XX - Basic settings group XXX
Start
wait XXs
XX - end of communication
connect with the control unit XX - Brake electronics
XX - Measured values group XXX
required values:
field X = -X,X - +X,Xm/sX
XX - end of communication
Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
- engine speed = idling
- on-board voltage > XXV
Start the engine
turn the steering wheel full way - right side
turn the steering wheel full way - left
drive the car over a short path with a maximum speed of XX km/h
Stop in straight direction, do not switch of the ignition - engine speed = idling
connect with the control unit XX - Brake electronics
XX - Measured values group XXX
required values:
field X = -X,X - +X,Xm/sX
connect with the control unit XX - Parking brake/Handbrake
XX - Basic settings group XXX
Start
wait XXs
XX - end of communication
connect with the control unit XX - Brake electronics
XX - Measured values group XXX
required values:
field X = -X,X - +X,Xm/sX
XX - end of communication
Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.