Diagnostic procedures for a VAG diagnostics
Database for coding vehicle control units Volkswagen - VAG
Software versions
VIN - Code validator
VW / Touareg (7L) / 05-Start authorisation / Start authorisation
Search:
Search area:
| Mark | Model | Control unit | Diagnostic operation |
|---|
Mark 
Model
Control unit
Diagnostic operation
Diagnostic procedure
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.
Conditions:
- on-board voltage > XX,X V - use charger
- it is possible to adapt a maximum of X keys
- all keys must be either new, or already adapted to this vehicle
connect with the control unit XX - Start authorisation
XX - Measured values group XXX
the first group of XX digits = VIN
the second group of XX digits = Immo-ID
XX - end of communication
switch on the ignition
depress and hold brake pedal - XX s
connect with the control unit XX - Start authorisation
XX - Measured values group XXX
required values:
field X = X
if values are not achieved - this key cannot be adapted
XX - Measured values group XXX
required values:
field X = X s
field X = X s
field X = X s
field X = X s
if values are not achieved - leave the ignition on until the counters zero
XX - Security access
enter value: Vehicle PIN
XX - Adaptation channel XX
stored value = number of adapted keys
enter value: total number of keys
Test
Save
XX - end of communication
- remove the ignition key
- switch on the ignition
key in ignition adapted
now, within a period of XXs, gradually switch the ignition on using all the keys to be adapted
Created on: XX.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
- on-board voltage > XX,X V - use charger
- it is possible to adapt a maximum of X keys
- all keys must be either new, or already adapted to this vehicle
connect with the control unit XX - Start authorisation
XX - Measured values group XXX
the first group of XX digits = VIN
the second group of XX digits = Immo-ID
XX - end of communication
switch on the ignition
depress and hold brake pedal - XX s
connect with the control unit XX - Start authorisation
XX - Measured values group XXX
required values:
field X = X
if values are not achieved - this key cannot be adapted
XX - Measured values group XXX
required values:
field X = X s
field X = X s
field X = X s
field X = X s
if values are not achieved - leave the ignition on until the counters zero
XX - Security access
enter value: Vehicle PIN
XX - Adaptation channel XX
stored value = number of adapted keys
enter value: total number of keys
Test
Save
XX - end of communication
- remove the ignition key
- switch on the ignition
key in ignition adapted
now, within a period of XXs, gradually switch the ignition on using all the keys to be adapted
Created on: XX.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.
You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.