VW / Touareg (7P) / 17 - Dashboard KOMBI VDD RM09 [EV_Kombi_UDS_VDD_RM09 A04723] / Change to fixed service interval QG2

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- engine speed = X
- Some control units may require that a non-zero number of the shop, importer and device be entered on the diagnostics equipment. This is the identification of the service / diagnostics equipment, which is provided by the manufacturer to the Volkswagen Group. Specific values may be required and/or in some case, it suffices that the values should be non-zero.
- applies only to control units with UDS protocol

Note:
- if the unit does not accept the values you have entered, it may happen that it is blocked by a previous unsuccessful attempt. In such case, turn-off the ignition for X minutes and repeat the operation

- it may happen that it is not possible to set the desired interval on the unit for the reason that the interval values were earlier changed unprofessionally. In such case, perform complete setting of the interval by procedure for change of interval

connect with the control unit XX - dashboard

XX - Adaptation UDS

select item in drop-down menu:

IDEXXXXX-MASXXXXX - WIV/ESI: coding of extended service intervals - WIV/ESI or SIA status
enter value: WIV/ESI or SIA ON
Start

IDEXXXXX-MASXXXXX - WIV/ESI: coding of extended service intervals - selection of WIV/ESI or SIA
enter value: WIV
Start

IDEXXXXX-MASXXXXX - WIV/ESI: coding of extended service intervals - oil level
enter value: oil level - evaluation - YES
Start

IDEXXXXX-MASXXXXX - WIV/ESI: coding of extended service intervals - oil presure
enter value: oil presure - dynamic
Start

IDEXXXXX-MASXXXXX - WIV/ESI: coding of extended service intervals - radio controlled clock receiver
enter value: radio controlled clock receiver - NO
Start

IDEXXXXX-MASXXXXX - WIV/ESI: coding of extended service intervals - oil quality
enter value: bad oil quality
Start

IDEXXXXX-MASXXXXX - WIV/ESI: coding of extended service intervals - TOG
enter value: connected with instrument panel - YES
Start

Log-in Buy