VW / Transporter 98-03 (7D) / immobiliser / Adaptation after replacement of engine control unit from 00 with CAN-Bus

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

Conditions:
- install component: engine control unit
- before this operation, take down the identification and coding of the initial control unit
- first execute the function: Coding

connect with the control unit XX - engine

XX - Adaptation channel XX
enter value: Vehicle PIN
Test
Save

system indicator light: Immobiliser - off

switch ignition off for: XX s

check of error memory

Note:
- If this procedure is not done properly, the immobilizer blocks for XX minutes; it is necessary to switch-off the ignition and wait.
- The newly installed and adapted control unit has adopted the VIN, SKZ and PIN and shall continue to use initial PIN of the vehicle

Created on: X.XX.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy