VW / Transporter 98-03 (7D) / immobiliser / Coding from 05/00

Search: Search area:

Mark	Model	Control unit	Diagnostic operation

Mark

Select a vehicle make or a common group such as Service Intervals, Engines, Transmissions, Immobilizers and Independent Heaters.

Model

Control unit Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Select the desired control unit as accurately as possible. The UDS identifier EV_xyz can be found in the VCDS after connecting to the control unit and then in the Extended Identification.

Diagnostic operation Select the desired diagnostic procedure.

Diagnostic procedure

You are not logged! System works in DEMO mode only now where numbers are replaced with X characters. For 49 EUR only You will get access into full system. You can pay by credit card or bank transfer. Click BUY button for purchase and You will get login to diagnostic procedures database imediatelly.

Log-in Buy

XXXXX

- For all LUPO models with communication between engine and immobiliser via CAN-Bus
- The rest of the LUPO models with communication between the engine control unit and the immobiliser via W-line (K-line) are automatically self-coded according to the speed by the engine control unit

Note:
Perform after replacement of immobiliser control unit

If the coded immobiliser control unit is in a vehicle with a different generation engine control unit, it may happen that communication fails after coding and the code is set to XXXXX and defective control unit is written to error memory

Created on: XX.X.XXXX XX:XX:XX (hnz) Copyright © XXXX-XXXX, AutoComSoft Ltd All rights reserved.

Log-in Buy