Dijagnostičke procedure za VAG dijagnostiku
Baza podataka za kodiranje kontrolnih jedinica Volkswagen - VAG
Software versions
Validator VIN koda- Scan Explorer
VW / e-tron (GE) / 6C - Kamera za hod u nazad "rikverc" [EV_CamSysRVRVCPANAMLBEv 005010] / Kalibracija kamere
Traži - Search:
Područje pretrage:
| Proizvođač | Model | Kontrolna jedinica - Control unit | Dijagnostička operacija - Diagnostic operation |
|---|
Proizvođač 
Model
Kontrolna jedinica - Control unit
Dijagnostička operacija - Diagnostic operation
Dijagnostička procedura
Niste prijavljeni! Sistem radi u DEMO modu samo sada kada su brojevi zamenjeni X znakovima. Za samo 49 EUR dobićete pristup celom sistemuu. Možete platiti kreditnom karticom ili bankovnim prenosom. Kliknite [KUPI] za kupovinu i odmah dobijate prijavu u bazu podataka dijagnostičkih postupaka.
Conditions:
- tailgate: closed
- Calibration equipment (VAS XXXX) , Measuring Laser (VAS XXXX/X) installed according to instructions
- Error memory empty except BXXXXXX - basic setting not done
connect with the control unit XC - reverse camera
Advanced Measured Values
select item in menu:
IDEXXXXX - system: status
TIP: For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window
desired condition:
- passive
- passive - waiting
- active
- active - waiting
- OFF
continue
If the camera is mounted in rear logo:
XX - Actuators
select item in menu:
IDEXXXXX - reverse camera: engine
activate
measure the height from the floor to the camera = A [mm] (Note the measured value)
measure the distance of the calibration jig from the rear axle = B [mm] (Note the measured value)
measure the height of the calibration jig from the floor = C [mm] (Note the measured value)
XX - Basic settings
select item in menu:
IDEXXXXX-MASXXXXX - reverse camera system: calibration
Input the parameter:
A
B
C
activate default settings
wait XXs
desired condition: Successfully completed
End of test
- tailgate: closed
- Calibration equipment (VAS XXXX) , Measuring Laser (VAS XXXX/X) installed according to instructions
- Error memory empty except BXXXXXX - basic setting not done
connect with the control unit XC - reverse camera
Advanced Measured Values
select item in menu:
IDEXXXXX - system: status
TIP: For easier search in the menu, enter the code IDE, ENG or MAS into the "Filter" window
desired condition:
- passive
- passive - waiting
- active
- active - waiting
- OFF
continue
If the camera is mounted in rear logo:
XX - Actuators
select item in menu:
IDEXXXXX - reverse camera: engine
activate
measure the height from the floor to the camera = A [mm] (Note the measured value)
measure the distance of the calibration jig from the rear axle = B [mm] (Note the measured value)
measure the height of the calibration jig from the floor = C [mm] (Note the measured value)
XX - Basic settings
select item in menu:
IDEXXXXX-MASXXXXX - reverse camera system: calibration
Input the parameter:
A
B
C
activate default settings
wait XXs
desired condition: Successfully completed
End of test
Niste prijavljeni! Sistem radi u DEMO modu samo sada kada su brojevi zamenjeni X znakovima. Za samo 49 EUR dobićete pristup celom sistemuu. Možete platiti kreditnom karticom ili bankovnim prenosom. Kliknite [KUPI] za kupovinu i odmah dobijate prijavu u bazu podataka dijagnostičkih postupaka.